Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.

OEM Part - Manufacturer #WP3392519

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

OEM Part - Manufacturer #341241

Consider replacing the idler assembly while you have the dryer apart.

Microwave incandescent light bulb, 40 Watt. Has small screw in base. If the light bulb threads are corroded, or the bulb base is too large, the socket may also need to be replaced.

OEM Part - Manufacturer #8206232A

EveryDrop Ice & Water Refrigerator Filter 4 reduces 23 contaminants, including lead and mercury, asbestos, and industrial chemicals. Each filter provides 300 gallons of filtered water and should be changed every 6 months to ensure proper contaminant removal and flow rate. NSF certified.

OEM Part - Manufacturer #EDR4RXD1

Replace filter every 6 months or 300 gallons to maximize contaminant reduction

EveryDrop Ice & Water Refrigerator Filter 3 reduces 66 contaminants, including lead and mercury, asbestos, and industrial chemicals. Each filter provides 200 gallons of filtered water and should be changed every 6 months to ensure proper contaminant removal and flow rate. NSF certified.

OEM Part - Manufacturer #EDR3RXD1

Replace filter every 6 months or 200 gallons to maximize contaminant reduction

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later. This dryer maintenance kit contains all of the parts that are commonly defective when the dryer is noisy.
-Call with model# to verify if kit is compatible with your dryer.

OEM Part - Manufacturer #4392065

Dryer Repair Kit, includes drum belt, 4 rollers and idler pulley, For 27" wide dryers built 1965 and later and Thin Twins. This dryer maintenance kit contains all of the parts that are commonly worn when the dryer is noisy.

OEM Part - Manufacturer #4392067

Dryer heating element. If your dryer does not heat first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases the heating element will have a break in the element if defective. *May need wire connector to install heating element.

OEM Part - Manufacturer #279838

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Upper dishrack stop clip, Gray

OEM Part - Manufacturer #WPW10508950

40 Watt frosted appliance light bulb.

OEM Part - Manufacturer #8009

Refrigerator door shelf bin. Fits many side by side models. *Use complete model number to determine if this will work in your refrigerator.

OEM Part - Manufacturer #WPW10321304

Chrome drip bowl (also called a drip pan) for 8 inch burner on an electric range. The drip pan sits underneath the heating element to collect drips or spills around the burner.

OEM Part - Manufacturer #WPW10196405

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834