Refine Selection Here:
This part fits your Washer/Dryer Combo
Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
OEM Part - Manufacturer #279834
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer drum drive belt
OEM Part - Manufacturer #WP40111201
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer drum support roller
OEM Part - Manufacturer #WP37001042
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
This is a genuine replacement part. The model number and name for the following item is: Whirlpool 37001298 Dryer Drum Glide.
OEM Part - Manufacturer #WP37001298
Order by 6:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
OEM Part - Manufacturer #WP338906
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer Idler Pulley Assembly
OEM Part - Manufacturer #WP37001287
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Screw, 10-24 3/8
OEM Part - Manufacturer #WP90767
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
OEM Part - Manufacturer #W10169313
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Idler pulley wheel and bearing assembly. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
OEM Part - Manufacturer #WPY54414
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Drum drive motor
OEM Part - Manufacturer #WP2200376
Order by 7:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Drum Felt Seal
OEM Part - Manufacturer #WP37001132
Required with this product:
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
The Whirlpool Blower Wheel 56000 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It replaces several part numbers and caution should be taken when servicing or repairing the appliance.
OEM Part - Manufacturer #56000
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Igniter (Bracket is no longer included.) If your old igniter was round you will need to order the bracket in the related parts below.
OEM Part - Manufacturer #WP37001308
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Door catch kit, includes catch and clip (metal) Replace both parts for best results
OEM Part - Manufacturer #LA-1003
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Drum support roller axle
OEM Part - Manufacturer #WP40113601
Order by 8:00 PM ET, this part ships TODAY!
