Amana Washing Machine Parts

Door lock latch assembly

Screw, 10-24 x 1/2

Washing machine agitator repair kit with a short length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

If the bolt is stripped, it should be replaced.

Machine Control Unit (MCU)

Self-tapping screw.

Door hinge pin cap

Includes latch assembly, one white and one gray lid lock bezel. Lid must be closed for washer to fill, wash, drain, or spin. If the machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.

Water inlet valve and inlet assembly with thermistor for water temp sensing. The water inlet valve opens to allow water to enter the washing machine. If the water inlet valve is defective, the wash may fill slowly or not fill at all.

White washer lid strike assembly. The strike is what the lid lock hooks onto to lock the washing machine lid. If old strike looks different the latch may need to be replaced as well.

Replacement agitator kit

Washing machine door boot. If the washer is leaking, the door boot may have a tear in it. Overloading the washer is the most common cause for a torn door boot.

Check out the Related Items for boot seal clamps and a good washing machine cleaner.

Washing machine main tub seal

If this seal fails water will leak out from the underside of the plastic outer tub.

Spring clip inside control knob